Well my last few nights hobby work and I have finally got this put together...
Its a Resin kit, and needed the usual trimming and scraping and bubble holes filling. Thankfully there weren't too many of these and none in any critical areas.
It's been a bit of a mission to assemble it... the front end on the sleigh required all three sleigh pieces to be heated in hot water and bent to shape. Much trial and error and tweaking and reheating until things worked out.
Radagast himself was in two pieces; main body, and cloak with right-arm, which was not too bad to glue together and the parts lined up well.
The side little terrain bits were easy to trim and assemble...
Of course the last bits were working out how the rabbits went together. There's 4 strands of them which again were a bit of trial and error to see which combos would be the best fit.
I had to trim some pieces of resin from the sprue to shape to join the reigns between each two strands. Fiddly work but its worked out OK, and the joints have then been concealed with a smear of liquid greenstuff over the top.
So finally assembled and ready to be primed. It will be joining my entries for the Analogue Hobbies painting challenge and I feel will make a great entry in the 'comedic' category... :)